Temperature Sensor Types including Thermocouples, Thermistors, Thermostats and Resistive Temperature Devices.There are four commonly used temperature sensor types: 1. Negative Temperature Coefficient (NTC) thermistor 2. Resistance Temperature Detector (RTD) 3. Thermocouple 4. Semiconductor-based sensors
DHT11 Digital Temperature and Relative Humidity Sensor
Features:
Low cost3 to 5V power and I/Omax current use during conversion 2.5mA (while requesting data)humidity Range 20-80% with 5% accuracytemperature Range 0-50°C with ±..
Digital thermostat
temperature controller regulator
DC12V Intelligent digital
thermostat temperature controller regulator With NTC sensor W1401 thermostat
Description:
Temperature
range: -9-99 centigrade Accuracy:
1 centigrade Control
accuracy: 1..
DS1621-Digital Thermometer & Thermostat FEATURESTemperature measurements require no external components.Measures temperatures from -55°C to +125°C in 0.5°C increments. Fahrenheit equivalent is -67°F to 257°F in 0.9°F increments.Temperature is read as a ..
DS18B20 - Digital
Thermometer
Description
The
DS18B20 digital thermometer provides 9-bit to 12-bit Celsius temperature
measurements and has an alarm function with nonvolatile user-programmable upper
and lower trigger points. The DS18B20 communicates over a 1-Wire bus that by
defin..
Description:Measure temperature and relative humidity using a simple interface that
requires just three wires to the sensor: GND, power, and data. Supported
by an Arduino library that makes it very easy to read values into your
project, so with a single I/O line from your microcontroller you c..
Features
Directly Calibrated to the Kelvin Temperature Scale1°C Initial Accuracy AvailableOperates from 400 µA to 5 mALess than 1-Ω Dynamic ImpedanceEasily CalibratedWide Operating Temperature Range200°C OverrangeLow Cost..
LM35D-Temperature Sensor Description:LM35 is a precision IC temperature (in oC) sensor with its output proportional to the temperature.Temperature range -55°C to 150°C.Output voltage change by 10mV to every oC rise/fall Pin Description: Pin No 1 Supply voltag..
Specifications:
- Dia 4mm,Length 40mm,Leads 500mm
- Resistance of 100 ohms at 0 Celsius and 138.4 ohms at 100 Celsius
- 3-wire configuration, an extra cable which acts exclusively as an output stabilizer.
- Stripped Ends Termination.
- Temperature measurement range: -50℃~300℃..
20D9 NTC ThermistorStrong power and strong capability of surge current protectionCharacteristics Fast response to the rapidly surgeBig material constant (B value)Small remain resistance. High reliability Extensive operating range Operating temp -55℃~+200℃ switching power supply ·UPS power supply, el..
10KΩ NTC ThermistorDescription and application :10K thermistor with a negative temperature coefficient. Resistance: 10k ohm (25 degrees C)Max. Power dissipation
100mWThermistor Tolerance: -5%
to +5%Mounting Type: Through HoleGood choice for temp-sensing applications.applications include tempe..
Specifications:
Adopt the NTC thermistor sensor, sensitivity is goodThe comparator output, signal clean, good waveform, driving ability is strong, for more than 15 ma.With potentiometer to adjust temperature detection thresholdWorking voltage: 3.3 V to 5 VOutput form: digital switch output (0 and..