GPS Satellite Receiver units outputing standard NMEA signals. Add Satellite postioning to your project. Easy to integrate they just need a serial UART port.
A GSM modem is a wireless modem that works with GSM networks.A GPRS modem is a GSM modem with additional support for GPRS technology for data transmission.
GPRS means: 'General Packet Radio Service'. It is based on a packet-switched technology, as an extension to GSM (note thatGSM is a circuit-switched). An advantage of GPRS over GSM is that GPRS has a much higher data transmission speed.GPRS can be used as the bearer of SMS. If SMS over GPRS is used, an SMS transmission speed of about 30 SMS messages per minute may be achieved. This is much faster than SMS over GSM.
Description: Wireless RF Module CC2500 2.4GHz options is suitable for delivering clear channel assessment, data buffering, wake on radio, burst transmissions, link quality indication. Further, it comes with option of Manchester coding of data stream by modulator and decoded by demodulator. Some..
ESP-01-ESP8266 WIFI ModuleDESCRIPTION:These modules include 1MB (8Mbit) of flash memoryThe ESP8266 Serial/UART to WiFi module is a great way to connect your Arduino or other microcontroller projects to a WiFi networkCreate your next internet of things (IoT) project with affordable network connectivi..
ESP-201-ESP8266 WIFI ModuleFeaturesSize: 25 x 35mm26 pinsBreadboard compatible pin spacing802.11 b/g/nPower: 3.3VOther Features ESP8266 serial portThe ESP-201 is a breadboard friendly ESP8266 WIFI module.Can be used as the IO moduleAll IO lead outWith antenna, farther than othersIPX interface..
2 CHANNEL IR REMOTE CONTROLCHENNEL 1 FAN (UPTO 200W)CHENNEL 2 LIGHT/BULB (100W)FAN SPEED CONTROLINDICATOR OF STATE OF FAN/LIGHTIF POWER FAILS IT START FROM LAST STATEMORE DETAILS IN USER MANUALPACKAGE - 1 MODULE + 1 REMOTE..
nRF24L01 module is a 2.4GHz transceiver module Pair (2 pcs).Please note that the nRF24L01 work in the 1.9 to 3.6v low voltage , so if you want to connect it to 5V pins which current more than 10mA , please add a 2K resister for limiting.Interface with Arduino. http://playground.arduino.cc/Inte..
4 Channel RF Remote Controller Board - 433/315 MHz with RelayTransmitter boardInput voltage – 9V (9V cell) DC 4 switches (for Forward, Backward, Left and Right Robot Control)8-bit address Switch (Rx and Tx both have same Address)Receiver BoardInput voltage – 12V DC (24V DC if Relay Rating 24V)8-bit ..
8 Channel RF Remote Controller Board - 433/315 MHz with RelayTransmitter8 switch for 8 direction control4 motor (2x (2 motors in parallel connection)) for basic Robot and 2 motors for other tasksPower Supply – 9V DC (9V cell)4 PIN DIP switch for ADDRESS (*** RX TX have Same ADDRESS)Antenna should st..