Remote Control Board 8 Channel RF - 433/315 MHz with Relay

8 Channel RF Remote Controller Board - 433/315 MHz with Relay

Transmitter

• 8 switch for 8 direction control
• 4 motor (2x (2 motors in parallel connection)) for basic Robot and 2 motors for other tasks
• Power Supply – 9V DC (9V cell)
• 4 PIN DIP switch for ADDRESS (*** RX TX have Same ADDRESS)
• Antenna should straight (-------------)

Receiver Board

• Power Supply 12V DC – (1.3Ah -7Ah) Battery
• ** For Heavy load Robot (10-15Kg) use 12V-7Ah battery and increase the thickness of high current flowing track of Receiver PCB (Contact seller)
• 4 PIN DIP switch for ADDRESS (*** RX TX have Same ADDRESS)
• Screw terminal1 – motor 1 (connect 2 motors in parallel)
• Screw terminal2 – motor 2 (connect 2 motors in parallel)
• Screw terminal3 – motor 3 (connect 1 motor for user task)
• Screw terminal4 – motor 4 (connect 1 motor for user task)
• All motor must move smoothly (if not your RX system will consume high current)
• **Place  Receiver PCB on non-conducting surface (To avoid short circuit)